Lawn Technicians
Sprinkler & Irrigation
Denver Metro · Licensed Contractor
New installation, sprinkler repair, add ons and drip lines. Honest work, clean job sites and systems built to handle Colorado seasons.
What we do
Every system we touch gets the same treatment: proper diagnosis, quality parts and a walkthrough when the work is done.
Seasonal tune-ups and full diagnostics that keep every zone running the way it was designed to. Our technicians pressure-test the system, locate leaks and breaks, adjust head arcs and spray patterns, clean clogged nozzles, and reprogram controllers so water reaches the turf instead of the sidewalk.
From a single broken head to a complete system designed from scratch. We map your property, calculate flow and pressure, lay out zones for even coverage, trench and install lines, heads and valves, then walk you through the finished controller settings before we leave the job.
The device that keeps irrigation water from flowing back into your drinking supply. We install, rebuild and repair backflow assemblies to code, replace worn internals and damaged units, and make sure your home or property stays protected and compliant.
Spring start ups bring the system back online safely: valves opened slowly, heads checked, zones tested and timers set for the season. Fall blow outs clear every line with compressed air so trapped water can't freeze, crack pipe or ruin valves over a Colorado winter.
Our work
Real systems, real yards. Installs, repairs, backflow work, controllers and winter blow outs.
Our service van arriving on site — new installation, sprinkler repair, add ons and drip lines, stocked and ready.
Fresh poly lateral line laid in a hand-cut trench, kept shallow and tight so the turf recovers fast.
Replacing an in-ground zone valve and re-splicing the field wiring with waterproof connectors.
Interior shut-off and drain assembly serviced ahead of a backflow preventer installation.
Exterior pressure vacuum breaker installed to code, protecting the home's drinking water supply.
Digging out a valve box to trace a failing zone back to its manifold connection.
Broken lateral line exposed in rock and clay, cut back clean before a new fitting goes in.
Irrigation shut-off valve isolated at the main before a fall blow out.
Four-zone manifold rebuilt in a new box with clean valve spacing and labeled wiring.
New timer programmed and bench-tested before it goes on the wall.
Older wall-mounted controller diagnosed and rewired zone by zone.
Field wiring landed on the terminal strip and traced back to each valve.
Four-station controller mounted, powered and set on a seasonal watering schedule.
Careful hand digging at the foundation to reach a buried main line without damaging what's around it.
Zone valves numbered and serviced inside the box so future repairs are simple.
Copper riser and brass backflow assembly set square against the house with isolation valves.
Compressor line connected at the backflow to clear every zone of water before winter.
Valve and wire splice exposed in the trench during a zone-down diagnosis.
Two replacement valves set on the manifold with clamped risers and clean tee work.
Valve serviced inside a deep concrete sleeve and drained back to gravel.
Older backflow assembly evaluated for rebuild or replacement.
Valve boxes seated flush and covered so the yard is left clean and mower-safe.
Silted-in valve box cleaned out and the wire nuts replaced with proper grease caps.
Four zones manifolded and wired in a single box, each line numbered for easy service.
Impact head raised on a riser to clear a rough grade during a system rebuild.
Yard hydrant and supply line set before the new sprinkler layout goes in.
Main line coupling replaced at the foundation after a split was located and cut out.
Ball valve and backflow device serviced at the house, ready for spring start up.
Manifold and new zone line staged in the trench before backfill.
Controller opened up, wiring inspected and the transformer verified before reprogramming.
Hours
Early starts, seven days a week. Call or text any time and we'll get back to you.
Areas served
Serving Denver and the following areas:
Tell us what your system is doing and we'll tell you what it needs.
720-280-5648